Wrap spare cable around the inside of the light, position the lights locating tabs(back of light), so they are just prior to fitting into the bracket, push the light firmly against the pool wall and twist clockwise until the light is completely secure.

Under no circumstances should the cable run through the bracket.

1. Light should be set 30cm-40cm below the water level.
2. The outlet for the conduit should be positioned so as not to interfere with the Mounting Ring in any way. (Refer to Diagram 1).
3. Set conduit in wall before concrete is sprayed.
4. Render or Marblesheen Mounting Ring into wall. Ensure outer face of Mounting Ring is flush with the finished pebble surface. (Refer Diagrams 1 & 2).
5. Wind 2-3 coils of cable around the base of the light to enable the light to be
removed from the water for servicing.
6. Position the light's locating tabs ( back of light ), so they are just prior to
fitting into the bracket, push the light firmly against the pool wall and twist
clockwise until the light is completely secure.
7. The transformer or remote control needs to be installed in an easily accessible waterproof area to allow for servicing when required.

*Electronic Smart switches may not be suitable to use for sequencing.